Makita 5" Sjsii High-power Angle Grinder Instruction Manual – Page 9

Posted on 11 Jun, 2019
Manufacturer: Makita
Category: Angle Grinders
Product: Makita 5" Sjsii High-power Angle Grinder
Model Number: GA5042C
Pages: 48
File size: 2 MB

9
1
2
3
012802
Mount the inner flange onto the spindle. Fit the
wheel/disc on the inner flange and screw the lock nut
onto the spindle.
1
2
012727
To tighten the lock nut, press th
e shaft lock firmly so that
the spindle cannot revolve,
then use the lock nut wrench
and securely tighten clockwise.
To remove the wheel, follow the installation procedure in
reverse.
Installing or removing flex wheel
(optional accessory)
WARNING:
Always use supplied guard when flex wheel is on
tool. Wheel can shatter during use and guard helps
to reduce chances of personal injury.
1
2
3
4
012740
Follow instructions for depressed center wheel but also
use plastic pad over wheel. See order of assembly on
accessories page in this manual.
Installing or removing abrasive disc
(optional accessory)
NOTE:
Use sander accessories s
pecified in this manual.
These must be purchased separately.
1
2
3
012742
Mount the rubber pad onto the spindle. Fit the disc on the
rubber pad and screw the s
anding lock nut onto the
spindle. To tighten the sandi
ng lock nut, press the shaft
lock firmly so that the spindle cannot revolve, then use
the lock nut wrench and securely tighten clockwise.
To remove the disc, follow the installation procedure in
reverse.
Installing or removing dust cover attachment
(Optional accessory)
WARNING:
Always be sure that the tool is switched off and
unplugged before installing or removing the
dust cover attachment.
Failure to do so causes
damage to the tool or a personal injury.
There are four pieces of dust cover attachment and each
is used in one of different positions.
1
2
3
4
012731
Set the dust cover attachment so that the marking (A, B,
C or D) places as shown. Snap its pins in the vents.
Dust cover attachment can be removed by hand.
NOTE:
Clean out the dust cover attachment when it is
clogged with dust or foreign matters. Continuing
operation with a clogged dust cover attachment will
damage the tool.
1. Marking A
2. Marking B
3. Marking C
4. Marking D
1. Sanding lock nut
2. Abrasive disc
3. Rubber pad
1. Lock nut
2. Flex wheel
3. Plastic pad
4. Inner flange
1. Lock nut wrench
2. Shaft lock
1. Lock nut
2. Depressed
center wheel
3. Inner flange