Makita 18v Lxt Lithium-ion Compact Brushless Cordless 1/2" Driver-drill Kit (2.0ah) Instruction Manual – Page 5

Posted on 11 Jun, 2019
Manufacturer: Makita
Category: Driver-Drills
Product: Makita 18v Lxt Lithium-ion Compact Brushless Cordless 1/2" Driver-drill Kit (2.0ah)
Model Number: XFD12R
Pages: 20
File size: 4 MB

5 ENGLISH
Indicating the remaining battery
capacity
Only for battery cartridges with "B" at the end of the
model number
1
2
1.
Indicator lamps
2.
Check button
Press the check button on the battery cartridge to indi-
cate the remaining
battery
capacity.
The indicator
lamps
light up for few seconds.
Indicator lamps
Remaining
capacity
Lighted
Off
Blinking
75% to 100%
50% to 75%
25% to 50%
0% to 25%
Charge the
battery.
The battery
may have
malfunctioned.
NOTE:
Depending on the conditions of use and the
ambient temperature, the indication may differ slightly
from the actual capacity.
Tool / battery protection system
The tool is equipped
with a tool/battery
protection
sys
-
tem. This system
automatically
cuts off power to the
motor to extend
tool and battery
life. The tool will auto
-
matically stop during operation if the tool or battery is
placed under one of the following conditions:
Overload protection
When the tool/battery is operated in a manner that causes
it to draw an abnormally high current, the tool automat
-
ically stops without any indication. In this situation, turn
the tool off and stop the application that caused the tool to
become
overloaded.
Then turn the tool on to restart.
Overheat protection
When the tool/battery is overheated, the tool stops
automatically. In this situation, let the tool/battery cool
before turning the tool on again.
Overdischarge protection
When the battery capacity is not enough, the tool stops
automatically. In this case, remove the battery from the
tool and charge the battery.
NOTE:
Overheat protection (for battery) will work only
with batteries with star marking.
1
1.
Star marking
Switch action
1
1.
Switch trigger
CAUTION:
Before installing the battery car-
tridge into the tool, always check to see that the
switch trigger actuates properly and returns to
the "OFF" position when released.
To start the tool, simply
pull the switch
trigger.
Tool
speed is increased by increasing pressure on the switch
trigger. Release the switch trigger to stop.
NOTE:
The tool automatically
stops if you keep pull
-
ing the switch trigger for about 6 minutes.
Electric brake
This tool is equipped
with an electric
brake. If the tool
consistently fails to quickly stop after the switch trigger
is released, have the tool serviced at a Makita service
center.