Makita 18v Lxt Lithium-ion Compact Brushless Cordless 1/2" Driver-drill Kit (2.0ah) Instruction Manual – Page 6

Posted on 11 Jun, 2019
Manufacturer: Makita
Category: Driver-Drills
Product: Makita 18v Lxt Lithium-ion Compact Brushless Cordless 1/2" Driver-drill Kit (2.0ah)
Model Number: XFD12R
Pages: 20
File size: 4 MB

6 ENGLISH
Lighting up the front lamp
1
1.
Lamp
CAUTION:
Do not look in the light or see the
source of light directly.
Pull the switch
trigger
to light up the lamp. The lamp
keeps on lighting while the switch trigger is being pulled.
The lamp goes out approximately
10 seconds
after
releasing the switch trigger.
NOTE:
When the tool is overheated, the tool stops
automatically
and the lamp starts flashing.
In this
case, release
the switch
trigger.
The lamp turns off in
one minute.
NOTE:
Use a dry cloth to wipe the dirt off the lens of
the lamp. Be careful not to scratch the lens of lamp, or
it may lower the illumination.
Reversing switch action
1
A
B
1.
Reversing switch lever
CAUTION:
Always check the direction of
rotation before operation.
CAUTION:
Use the reversing switch only after
the tool comes to a complete stop.
Changing the
direction of rotation before the tool stops may dam-
age the tool.
CAUTION:
When not operating the tool,
always set the reversing switch lever to the neu
-
tral position.
This tool has a reversing
switch
to change
the direction
of rotation. Depress the reversing switch lever from the
A side for clockwise
rotation
or from the B side for coun
-
terclockwise rotation.
When the reversing switch lever is in the neutral posi-
tion, the switch trigger cannot be pulled.
Speed change
1
1.
Speed change lever
CAUTION:
Always set the speed change lever
fully to the correct position.
If you operate the
tool with the speed change lever positioned halfway
between the "1" side and "2" side, the tool may be
damaged.
CAUTION:
Do not use the speed change lever
while the tool is running.
The tool may be damaged.
Displayed
Number
Speed
Torque
Applicable
operation
1
Low
High
Heavy load-
ing operation
2
High
Low
Light loading
operation
To change
the speed,
switch
off the tool first. Push
the speed change lever to display "2" for high speed
or "1" for low speed but high torque. Be sure that the
speed change lever is set to the correct position before
operation.
If the tool speed is coming down extremely during the
operation with display "2", push the lever to display "1"
and restart the operation.