Makita 18v Lxt Lithium-ion Compact Brushless Cordless 1/2" Driver-drill, Tool Only Instruction Manual – Page 5
Posted on 11 Jun, 2019
Product: Makita 18v Lxt Lithium-ion Compact Brushless Cordless 1/2" Driver-drill, Tool Only
Model Number: XFD12Z
File size: 4 MB
Indicating the remaining battery
Only for battery cartridges with "B" at the end of the
Press the check button on the battery cartridge to indi-
cate the remaining
light up for few seconds.
75% to 100%
50% to 75%
25% to 50%
0% to 25%
Depending on the conditions of use and the
ambient temperature, the indication may differ slightly
from the actual capacity.
Tool / battery protection system
The tool is equipped
with a tool/battery
tem. This system
cuts off power to the
motor to extend
tool and battery
life. The tool will auto
matically stop during operation if the tool or battery is
placed under one of the following conditions:
When the tool/battery is operated in a manner that causes
it to draw an abnormally high current, the tool automat
ically stops without any indication. In this situation, turn
the tool off and stop the application that caused the tool to
Then turn the tool on to restart.
When the tool/battery is overheated, the tool stops
automatically. In this situation, let the tool/battery cool
before turning the tool on again.
When the battery capacity is not enough, the tool stops
automatically. In this case, remove the battery from the
tool and charge the battery.
Overheat protection (for battery) will work only
with batteries with star marking.
Before installing the battery car-
tridge into the tool, always check to see that the
switch trigger actuates properly and returns to
the "OFF" position when released.
To start the tool, simply
pull the switch
speed is increased by increasing pressure on the switch
trigger. Release the switch trigger to stop.
The tool automatically
stops if you keep pull
ing the switch trigger for about 6 minutes.
This tool is equipped
with an electric
brake. If the tool
consistently fails to quickly stop after the switch trigger
is released, have the tool serviced at a Makita service